镧掺杂钡铁氧体-聚苯胺复合材料的制备与表征
Preparation and Characteristics of Lanthanum-doped Barium Ferrite
-polyaniline Composites
摘要 采用溶胶凝胶法制备了镧掺杂钡铁氧体(BaLaxFe12-xO19, x=0、0.01、0.03、0.05)。通过XRD表征表明它们的结晶性良好,均为单一的磁铅石型钡铁氧体晶相结构,随镧掺杂量的增加,得到的镧掺杂钡铁氧体的粒径随之减小。采用溶液原位聚合法制备镧掺杂钡铁氧体-聚苯胺复合材料,红外光谱分析可知聚苯胺-铁氧体纳米复合物的生成,揭示了聚合物分子链与铁氧体纳米粒子之间存在一定的键和作用,TEM表征显示复合材料粒子呈球形,且粒径为60~80 nm左右。随着铁氧体含量的降低,样品的磁性能随之降低,即铁氧体含量是影响磁性能的主要因素。
关键词 钡铁氧体;镧掺杂;聚苯胺;复合材料
Abstract: Lanthanum-doped barium ferrite (BaLaxFe12-xO19, x=0, 0.01, 0.03, 0.05)
was prepared by the sol-gel. XRD analysis showed that the samples had good
crystallization and were one of the magnetic type barium ferrite crystal structures.With
increasing of the lanthanum doping, the barium ferrite particle size is also decreased
At the same time in-situ polymerization in solution was used to prepare lanthanum-
doped barium ferrite-polyaniline composites. Fourier transform infrared spectroscopy
suggested that the lanthanum-doped barium ferrite-polyaniline composites had been
produced. TEM observation showed that the sample was spherical and that complex
particle size was about 60~80 nm. The sample test results of magnetic properties
showed that as the ferrite content decreased the sample magnetic properties
decreased, which indicated that the ferrite content was the main factor affecting the
magnetic properties.
Keyword: barium ferrite; lanthanum-doped; polyaniline; composites
看看这些对你有没有帮助...
本期目录
- 电力线通信室内互联技术电磁发射...
- 保护车载接收机的无线电骚扰测量...
- 解析315~600 kHz短距离设备电磁...
- EN 62233:2008测量方法解析 Anal...
- 巴西Anatel认证的安全要求 Safet...
- LED节能灯的安规要求 Safety Req...
- PCB信号传输线的特性阻抗控制 Co...
- 空间有效载荷电磁兼容设计 EMC D...
- 镧掺杂钡铁氧体-聚苯胺复合材料的...
- 羰基铁与炭黑共混制备吸波涂层的...
- 汽车电磁问题的FEKO仿真 FEKO Si...
- PCB 上PDN自阻抗双端口网络测量方...
- 串联锂离子电池组荷电状态评估方...
- 电磁兼容自适应扫描系统的研制 T...
- 印制线路板设计与布局布线(二) ...
- 2010年ITU-T SG5第二次全会综述 ...
- 2010 IEEE EMC 学术研讨会—电磁...
- 关于IEC 60598—1(八) CTL Dec...
查看完整目录>>